Work Procedure: Notes
WARNING: This page is about a different car, the 2024 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- Perform action test to verify the customer's concern.
- Perform action test and check the system operation after system diagnosis.
CAUTION:
- Fully understand the following items well before the road test;
- System description: SYSTEM DESCRIPTION
- Handling Precaution: HANDLING PRECAUTION
- CHECK BSW SYSTEM SETTING
- Start the engine.
- Check that the BSW system setting can be enabled/disabled on the information display.
- Turn OFF the ignition switch and wait for 5 seconds or more.
- Check that the previous setting is saved when the engine starts again.
>>
GO TO 2.
- BSW SYSTEM ACTION TEST
- Enable the setting of the BSW system on the information display.
- Turn BSW system ON.
- Check BSW operation according to the following table.
7 inch Information Display
Condition Action Indication on the BSW indicator Display on information display Buzzer BSW OFF - OFF OFF BSW ON Vehicle speed is less than approx. 29 km/h (18 MPH) - OFF BSW system indicator: White Speaker icon: White OFF BSW ON Vehicle speed is approx. 32 km/h (20 MPH) or more Vehicle is not detected - OFF BSW system indicator: White Speaker icon: White OFF Vehicle is detected Turn signal is OFF - ON BSW system indicator: White Speaker icon: White OFF Vehicle is detected before turn signal operates Turn signal is ON (vehicle detected direction) - Blink Yellow (Blink) Short continuous beeps BSW ON Vehicle speed is approx. 32 km/h (20 MPH) or more Vehicle is detected after turn signal operates Turn signal is ON (vehicle detected direction) - Blink Yellow (Blink) OFF BSW system indicator: Yellow (Blink) Speaker icon: White