Work Procedure
WARNING: This page is about a different car, the 2024 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- Always perform the front camera unit configuration after replacing the front camera unit.
- Always perform the camera aiming after removing and installing or replacing the front camera unit.
CAUTION:
The system does not operate normally unless the front camera unit configuration and the camera aiming adjustment are performed. Always perform them.
- FRONT CAMERA UNIT CONFIGURATION
Perform the front camera unit configuration with M.U.T.-III SE. Refer to WORK PROCEDURE .
>>
GO TO 2.
- CAMERA AIMING ADJUSTMENT
Perform the camera aiming adjustment with M.U.T.-III SE. Refer to WORK PROCEDURE .
>>
GO TO 3.
- PERFORM SELF-DIAGNOSIS
Perform the self-diagnosis of front camera unit with M.U.T.-III SE. Check if any DTC is detected.
Is any DTC detected?
YES >>
Perform the trouble diagnosis for the detected DTC. Refer to DTC INDEX .
NO >>
GO TO 4.
- ACTION TEST
- Perform the following system action test.
- LDW: Refer to Work Procedure INSPECTION PROCEDURE .
- LDP: Refer to Work Procedure INSPECTION PROCEDURE .
- Active Blind Spot Assist [ABSA]: Refer to WORK PROCEDURE .
- TSR: Refer to WORK PROCEDURE .
- Check that the each system operates normally.
>> WORK END
- Perform the following system action test.