PERMANENT DTC STATUS Mode
How to Display Permanent DTC Status
- Turn ignition switch OFF and wait at 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at 10 seconds.
- Turn ignition switch ON.
- Select "PERMANENT DTC STATUS" in "ENGINE" with M.U.T.-III SE.
NOTE:
Permanent DTCs stored in control module memory are displayed on the M.U.T.-III SE screen to show if a driving pattern required for erasing permanent DTCs is complete (CMPLT) or incomplete (INCMP)
.
CAUTION:
Since the "PERMANENT DTC STATUS" screen displays the previous trip information, repeat the following twice to update the information: "Ignition switch OFF", "Wait for more than 10 seconds" and "Ignition switch ON"
.
NOTE:
This mode is not used in regions that permanent DTCs are not regulated by law
.