Component Inspection

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Turn ignition switch ON.
4. Check the voltage between ECM harness connector terminals as per the following condition.

   ECM				Condition		Voltage
   Connector		+	-
   		Terminal
   Sensor 1	E16	158	159	Accelerator pedal	Fully released	0.76 V
   					Fully depressed	4.57 V
   Sensor 2		151	152		Fully released	0.39 V
   					Fully depressed	2.3 V

Is the inspection result normal? 

YES >>

INSPECTION END

NO >>

Replace accelerator pedal assembly. Refer to REMOVAL AND INSTALLATION .