Component Inspection

1. Disconnect combination switch (spiral cable) harness connector.
2. Check the resistance between combination switch harness connector terminals as per the following conditions.

   Combination switch (Spiral cable)			Condition	Resistance (Approx.)
   Connector	+	-
   	Terminals
   M154	21	36	MAIN switch: Pressed	Approx. 0
   			CANCEL switch: Pressed	Approx. 310
   			DISTANCE switch: Pressed	Approx. 740
   			SET- switch: Pressed	Approx. 1, 410
   			RES+ switch: Pressed	Approx. 2, 590
   			NOT OPERATE	Approx. 5, 456

Is the inspection result normal? 

YES >>

INSPECTION END

NO >>

Replace ACC steering switch. Refer to EXPLODED VIEW .