Component Inspection

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Perform "Throttle Valve Closed Position Learning". Refer to WORK PROCEDURE .
4. Turn ignition switch ON.
5. Set selector lever to D position.
6. Check the voltage between ECM harness connector terminals as per the following conditions.

   ECM				Condition		Voltage
   Connector		+	-
   		Terminal
   Sensor 1	F51	57	62	Accelerator pedal	Fully released	More than 0.36V
   					Fully depressed	Less than 4.75V
   Sensor 2		52			Fully released	Less than 4.75V
   					Fully depressed	More than 0.36V

Is the inspection result normal? 

YES >>

INSPECTION END

NO >>

Replace electric throttle control actuator. Refer to Exploded View REMOVAL AND INSTALLATION .