Component Function Check

Make sure that all of the following conditions are satisfied.

• Vehicle driven distance: More than 5, 000 km (3, 107 miles)
• Barometric pressure: 98.3 - 104.3 kPa (1.003 - 1.064 kg/cm² , 14.25 - 15.12 psi)
• Atmospheric temperature: 20 - 30°C (68 - 86°F)
• Engine coolant temperature: 75 - 95°C (167 - 203°F)
• Transmission: Warmed-up
  • After the engine is warmed up to normal operating temperature, drive vehicle until "ATF TEMP SEN" (CVT fluid temperature sensor signal) indicates more than 60°C (140°F).
• Electrical load: Not applied*
• Engine speed: Idle

*: Rear window defogger switch, air conditioner switch, lighting switch are OFF. Steering wheel is straight ahead.

>>: GO TO 2 

With M.U.T.-III SE

1. Refer to WORK PROCEDURE .
2. On M.U.T.-III SE screen, select "ENGINE" >> "Data List".
3. Select "B/FUEL SCHDL", "A/F ALPHA-B1" and "MASS AIR FLOW SENSOR (g/s)" in "DATA MONITOR" mode with M.U.T.-III SE.
4. Make sure that monitor items are within the SP value.

Is the inspection result normal? 

YES >>: END

NO >>: Refer to Diagnosis Procedure DTC DIAGNOSIS PROCEDURE .