Diagnosis Procedure
WARNING: This page is about a different car, the 2024 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK PUSH-BUTTON IGNITION SWITCH SIGNAL OUTPUT VOLTAGE
- Ignition switch OFF.
- Disconnect push-button ignition switch connector.
- Check voltage between push-button ignition switch harness connector and ground.
+ - Voltage (Approx.) Push-button ignition switch Connector Terminal M17 8 Ground 12 V
Is the inspection result normal?
YES >>
GO TO 4.
NO >>
GO TO 2.
- CHECK PUSH-BUTTON IGNITION SWITCH SIGNAL CIRCUIT (OPEN)
- Disconnect Keyless operation key unit connector.
- Check continuity between push-button ignition switch harness connector and Keyless operation key unit harness connector.
Push-button ignition switch Keyless operation key unit Continuity Connector Terminal Connector Terminal M17 8 M184 9 Existed
Is the inspection result normal?
YES >>
GO TO 3.
NO >>
Repair the harness or connector.
- CHECK PUSH-BUTTON IGNITION SWITCH SIGNAL CIRCUIT (SHORT TO GROUND)
Check continuity between push-button ignition switch harness connector and ground.
Push-button ignition switch - Continuity Connector Terminal M17 8 Ground Not existed Is the inspection result normal?
YES >>
Replace Keyless operation key unit. Refer to REMOVAL AND INSTALLATION .
NO >>
Repair the harness or connector.
- CHECK PUSH-BUTTON IGNITION SWITCH GROUND CIRCUIT (OPEN)
Check continuity between push-button ignition switch harness connector and ground.
Push-button ignition switch - Continuity Connector Terminal M17 1 Ground Existed Is the inspection result normal?
YES >>
GO TO 5.
NO >>
Repair the harness or connector.
- CHECK PUSH-BUTTON IGNITION SWITCH
Check push-button ignition switch. Refer to COMPONENT INSPECTION .
Is the inspection result normal?
YES >>
INSPECTION END
NO >>
Replace push-button ignition switch. Refer to REMOVAL AND INSTALLATION .