LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2023 >> Outlander ES, AWD >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Drive Mode System (DTC/Circuit Diagnosis) >> DTC/Circuit Diagnosis >> Drive Mode Select Switch Circuit >> Diagnosis Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis Procedure

  1. CHECK DRIVE MODE SELECT SWITCH SIGNAL CIRCUIT 
    1. Ignition switch OFF.
    2. Disconnect drive mode select switch harness connector and chassis control module harness connector.
    3. Check the continuity between drive mode select switch harness connector and chassis control module harness connector.
      CONNECTOR TERMINAL CONTINUITY SPECIFICATION

      Drive mode select switch BCM Continuity
      Connector Terminal Connector Terminal
      M186 3 M18 25 Existed
    4. Also check harness for short to ground and to power.

    Is the inspection result normal? 

    YES >>: GO TO 2  .

    NO >>: Repair/replace harness or connector.

  2. CHECK DRIVE MODE SELECT SWITCH GROUND CIRCUIT 

    Check the continuity between drive mode select switch harness connector and ground.

    CONNECTOR TERMINAL CONTINUITY SPECIFICATION

    Drive mode select switch - Continuity
    Connector Terminal
    M186 4 Ground Existed

    Is the inspection result normal? 

    YES >>: GO TO 3  .

    NO >>: Repair/replace harness or connector.

  3. CHECK DRIVE MODE SELECT SWITCH 

    Check drive mode select switch.

    Is the inspection result normal? 

    YES >>: INSPECTION END

    NO >>: Replace drive mode select switch. Refer to REMOVAL AND INSTALLATION .

scientia non olet · About LEMON Manuals