Work Procedure

PERFORM ZERO POINT RESET
1. Perform zero point reset.
  NOTE:
  When performing zero point reset, be careful of the items described as per the following.
  - Perform zero point reset after installing passenger seat to the vehicle
  - Never put any objects on passenger seat
  - Never apply excessive vibration to the vehicle
  - Never touch the vehicle
  - Never tilt the vehicle
2. Select start on "Zero point reset function" screen from, WORK SUPPORT of M.U.T.-III SE "OCCUPANT DETECTION".
3. "Zero point reset" starts.
>>

GO TO 2.
CONFIRMATION OF SETTING
1. Proceed to "Zero point reset function" screen from work support of M.U.T.-III SE "OCCUPANT DETECTION".
2. Check that "Already performed" or "Not yet performed" is displayed on "Zero point reset current status".
CAUTION:
- "Already performed" is displayed on "Zero point reset current status" if the seat is reinstalled by seat removal and installation, or zero point reset is already performed.
- "Zero point reset current status" displays "Not yet performed" if a new seat is installed. When electric motor switch ON without performing zero point reset, SRS air bag warning light keeps turning ON. When zero point reset is performed, SRS air bag warning light turns OFF.
- Air bag diagnosis sensor unit does not record whether or not zero point reset is performed.
Is condition "Already performed"?

YES >>

WORK END