Diagnosis Procedure

CONFIGURATION OF POWER STEERING CONTROL MODULE
Perform configuration of power steering control module. Refer to WORK PROCEDURE .

CAUTION: Do not replace the power steering control module Diagnostic Trouble Code has been completed.

>>

GO TO 2.
PERFORM DIAGNOSTIC TROUBLE CODE
With M.U.T.-III SE
1. Electric motor switch OFF to ON.
2. Erase self-diagnostic results for "EPS/DAST 3".
3. Pull the parking brake switch.
  NOTE: Check the parking brake switch indicator is turn On.
4. Electric motor switch OFF.
5. Get out of the vehicle and close all doors.
6. Wait 65 seconds.
  NOTE:
  - Check the parking brake switch indicator turn OFF.
  - If the rear brake caliper is heated, wait an hour so that parking brake switch indicator does not turn OFF.
7. Electric motor switch ON.
8. Perform Diagnostic Trouble Code for "EPS/DAST 3".
Is DTC detected?

YES >>

Replace the power steering control module (steering gear assembly). Refer to REMOVAL AND INSTALLATION .

NO >>

INSPECTION END