Ignition Switch Position Change Table By Push-Button Ignition Switch Operation
The ignition switch position can be changed by the following operations.
NOTE:
- When an Keyless operation key is within the detection area of inside key antenna or when Keyless operation key backside is contacted to push-button ignition switch, it is equivalent to the operations below.
- When starting the engine, the BCM monitors under the engine start conditions.
- Brake pedal operation condition
- Selector lever position
- Vehicle speed
Vehicle speed: less than 4 km/h (2.5 MPH)
| Power supply position | Condition | Push-button ignition switch operation frequency | |
|---|---|---|---|
| Selector lever | Brake pedal operation condition | ||
| OFF → ON | - | Not depressed | 1 |
| OFF → ON → OFF | - | Not depressed | 2 |
| OFF → START ON → START | P or N position | Depressed | 1 |
| Engine is running → OFF | - | - | 1 |
NOTE:
If the Keyless operation key unit cannot detect that the Keyless operation key is in the vehicle, ignition switch can be turned OFF by the press and hold the push-button ignition switch for 2 seconds or more.
Vehicle speed: 4 km/h (2.5 MPH) or more
| Power supply position | Condition | Push-button ignition switch operation frequency | |
|---|---|---|---|
| Selector lever | Brake pedal operation condition | ||
| Engine is running → OFF | - | - | Emergency stop operation |
| Engine stall return operation while driving | N position | Not depressed | 1 |
Emergency stop operation
- Press and hold the push-button ignition switch for 2 seconds or more.
- Press the push-button ignition switch 3 times or more within 1.5 seconds.