Work Procedure
WARNING: This page is about a different car, the 2023 Mitsubishi Outlander PHEV. However, it is still accessible from the selected car via links, so may be relevant.
When replacing ADAS control unit 2, it is necessary to write MAC key to ADAS control unit 2. Write MAC key to ADAS control unit 2 according to "MAC Key writing" procedure of "M.U.T.-III SE User's Manual".
CAUTION:
During MAC key writing, maintain the following conditions:
- When electric motor switch is ON
- M.U.T.-III SE is connected to internet
NOTE:
When the chassis number writing, MAC KEY writing or vehicle specification writing is carried out, DTC No. U2252-08 may be set in the PHEV-ECU, or DTC No. C1F04-61 may be set in the ADAS control unit 2. Therefore, carry out the following procedures after the writing.
- Check that the DTC No. C1F04-61 is set in the ADAS control unit 2.
- When the DTC is not set: Go to Step 2.
- When the DTC is set as a past trouble: Erase the DTC, then go to Step 2.
- When the DTC is set as a current trouble: Carry out the following procedures.
- Start the engine (set the drive mode to battery charge mode, or start the continuous idling mode) or drive the vehicle at 5 km/h or more.
- Change the power supply mode of the electric motor switch to OFF.
- Change the power supply mode of the electric motor switch to ON.
- Check whether the DTC No. C1F04-61 is set in the ADAS control unit 2.
When the DTC is set as a current trouble: Carry out the diagnosis procedures for the DTC No. C1F04-61, then go to Step 2.
When the DTC is set as a past trouble: Erase the DTC, then go to Step 2.
- Check that the DTC No. U2252-08 is set in the PHEV-ECU.
- When the DTC is not set: End the diagnosis.
- When the DTC is set as a past trouble: Erase the DTC, then end the diagnosis.
- When the DTC is set as a current trouble: Carry out the diagnosis procedures for the DTC No. U2252-08.