Setting The Target Board
WARNING: This page is about a different car, the 2023 Mitsubishi Outlander PHEV. However, it is still accessible from the selected car via links, so may be relevant.
Accurate adjustment of the radar alignment requires that the target board be accurately positioned.
CAUTION:
If the radar alignment is adjusted with the target board in the incorrect position, the FCM/PFCW systems do not function normally.
- TARGET BOARD HEIGHT ADJUSTMENT
Set the target board up to adjustable maximum height.
>>
GO TO 2.
- PREPARATION OF SETTING TARGET BOARD (1)
"A" - "E" ("C" - "F"): 2000 mm (78.7 in)
- Mark points "A", "B", "C" and "D" at the center of the lateral surface of each wheels.NOTE: Hang a string with a cone from the fender so as to pass through the center of wheel, and then mark a point at the center of the lateral surface of the wheel.
- Draw line "LH" passing through points "A" and "B" on the left side of vehicle.NOTE: Approximately 2 m (6.56 ft) or more from the front end of vehicle.
- Mark point "E" on the line "LH" at the positions 2000 mm (78.7 in) from point "A".
- Draw line "RH" passing through points "C" and "D" on the right side of vehicle in the same way as step 2.NOTE: Approximately 2 m (6.56 ft) or more from the front end of vehicle.
- Mark point "F" on the line "RH" at the positions 2000 mm (78.7 in) from point "C".
- Draw line "FW" passing through the points "E" and "F" on the front side of vehicle.
- Mark point "X" at the center of point "E" and "F" on the line "FW".CAUTION: Make sure that "E" to "X" is equal to "F" to "X".
>>
GO TO 3.
- Mark points "A", "B", "C" and "D" at the center of the lateral surface of each wheels.
- SETTING TARGET BOARD
Place the center of target board on point "G" at line "E-F" and install the target board.
CAUTION: For performing the radar alignment correctly, securely install (target board) to be parallel with the "E-F" line.L1: 2000 mm (78.7 in) L2: 0 mm (0 in) >>
GO TO 4.
- CHECK THE TARGET BOARD INSTALLATION AREA
Do not place anything other than target board in the space shown in the illustration (view from top).
(1) No object zone (2) Distance sensor (3) Target board W 3000 mm (118.11 in) L 1500 mm (59.06 in) >>
Go to RADAR ALIGNMENT