Removal And Installation: Notes
CAUTION:
- If the front transaxle assembly is removed, installed or replaced, perform the following tasks in numerical order.
- Stored Range Value Clear (Refer to STORED RANGE VALUE CLEAR ).
- Leaning of Movable Range (Refer to LEARNING OF MOVABLE RANGE ).
- Check Initial Learning Quantity (Refer to CHECK INITIAL LEARNING QUANTITY ).
- If the 12V battery is disconnected, the control timer which operates the engine forcibly will be reset. If the engine does not start for prolonged period after the reset, the fuel injection system may be clogged. Start the engine in battery charge mode. However, if the drive battery is near full charge, the engine may not start even in battery charge mode. In that case, wait until the drive battery is partially discharged.
| Removal steps | ||
|---|---|---|
| • | Engine assembly (Refer to Engine - Engine Mechanical, Engine Assembly REMOVAL AND INSTALLATION ) | |
| • | Front motor (Power unit) assembly - Refer to Electric Power Train - Electric Motor Control Unit (EMCU) and Motor (Electric Motor Unit), Motor (Electric Motor Unit) <Front> REMOVAL AND INSTALLATION | |
| • | Generator - Refer to Electric Power Train - Electric Motor Control Unit (EMCU) and Motor (Electric Motor Unit), Generator REMOVAL AND INSTALLATION | |
| 1. | Control wiring harness connection | |
| 2. | Harness bracket | |
| 3. | Torque rod adapter bracket | |
| 4. | Torque rod adapter stay | |
| >>A<< | 5. | Front transaxle assembly |