Component Inspection

Component Inspection

1. CHECK REAR POWER WINDOW SWITCH LH 1 
   1. Turn the power supply mode of the electric motor switch to OFF.
   2. Disconnect rear power window switch LH connector.
   3. Check continuity between rear power window switch LH terminals.

      Terminal		Continuity
      1	6	Not existed
      	7	Existed
      2	6	Not existed
      	7	Existed

   Is the inspection result normal? 

   YES: GO TO  2.

   NO: Replace rear power window switch LH. Refer to REMOVAL AND INSTALLATION .

2. CHECK REAR POWER WINDOW SWITCH LH 2 

   Check voltage rear power window switch LH terminals under the following conditions.

   Terminal		Condition		Voltage
   (+)	(-)
   1	Ground	12 V direct current supply between terminals 6 (+) and 3 (-).	NEUTRAL	0 V
   			DOWN	12 V
   2	Ground	12 V direct current supply between terminals 6 (+) and 3 (-).	NEUTRAL	0 V
   			UP	12 V

   Is the inspection result normal? 

   YES: GO TO  3.

   NO: Replace rear power window switch LH. Refer to REMOVAL AND INSTALLATION .

3. CHECK REAR POWER WINDOW SWITCH LH 3 
   1. Check voltage rear power window switch LH terminals under the following conditions.

      Terminal		Condition	Voltage
      (+)	(-)
      1	Ground	12 V direct current supply between terminals 6 (+) and 5 (-).	12 V
      		No current supply	0 V
      2	Ground	12 V direct current supply between terminals 6 (+) and 4 (-).	12 V
      		No current supply	0 V

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: Replace rear power window switch LH. Refer to REMOVAL AND INSTALLATION .