Component Function Check

Component Function Check

1. CHECK FUNCTION 

   Check rear power window motor LH operation with power window main switch (rear LH switch) or rear power window switch LH.

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: Refer to DIAGNOSIS PROCEDURE .

   Diagnosis Procedure 

2. CHECK REAR POWER WINDOW MOTOR LH INPUT SIGNAL 
   1. Turn the power supply mode of the electric motor switch to OFF.
   2. Disconnect rear power window motor LH connector.
   3. Turn the power supply mode of the electric motor switch to ON.
   4. Check voltage between rear power window motor LH harness connector and ground.

      (+)		(-)	Condition		Voltage
      Rear power window motor LH
      Connector	Terminal
      D205	1	Ground	Rear power window switch LH	UP	9 - 16 V
      				DOWN	0 - 1 V
      	2			UP	0 - 1 V
      				DOWN	9 - 16 V

   Is the inspection result normal? 

   YES: Replace rear power window motor LH. Refer to REMOVAL AND INSTALLATION .

   NO: GO TO 2  .

3. CHECK REAR POWER WINDOW MOTOR LH CIRCUIT 
   1. Turn the power supply mode of the electric motor switch to OFF.
   2. Disconnect rear power window switch LH connector.
   3. Check continuity between rear power window switch LH harness connector and rear power window motor LH harness connector.

      Rear power window switch LH		Rear power window motor LH		Continuity
      Connector	Terminal	Connector	Terminal
      D204	1	D205	2	Existed
      	2		1

   4. Check continuity between rear power window switch LH connector and ground.

      Rear power window switch LH		-	Continuity
      Connector	Terminal
      D204	1	Ground	Not existed
      	2

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: Repair or replace harness.