All Other Models
- Place transmission in Neutral and turn ignition switch to "START" position. Warning light should come on. If not, check bulb or wiring, and repair as necessary.
- Make sure that floor temperature is below 176°F (80°C). Remove rear seat and turn ignition switch to ignition "RUN" position. Warning light should go out.
- Heat floor area around temperature sensor. DO NOT heat floor temperature sensor directly. Warning light should glow when temperature is above specifications as shown in TEMPERATURE WARNING SYSTEM table.
- If warning light comes on and stays on, check wiring harness for a short or open circuit. Check condition of the fuel system and ignition system for proper operation.
- If light does not come on, check floor temperature sensor connector for continuity. If continuity exists after heating floor, replace temperature sensor. If continuity does not exist, check wiring for damage and repair as necessary.
- Turn ignition switch to ignition "RUN" position and disconnect floor temperature sensor connector. Light should stay on. If not, check the floor temperature relay for continuity.
- Check relay for continuity between pins No. 4 and 5. See Fig 1. Check that there is continuity between pins No. 1 and 3. Check that there is NO continuity between pins No. 1 and 2.
- With 12 volts applied across pins No. 4 and 5, continuity should exists between pins No. 1 and 2. No continuity should exist between pins No. 1 and 3. If relay does not test as indicated, replace floor temperature relay.
Courtesy of NISSAN NORTH AMERICA, INC.