Washer Circuit
- Connect negative voltmeter lead to pin 2 and positive lead to pin 14. Turn ignition to "ACC" and pull lever to washer position.
- Battery voltage should be present with washer off, and no voltage present with washer lever pulled. If not, check washer switch and wiring.
- Connect negative lead of voltmeter to pin 2 and positive lead to pin 26. Battery voltage should be present with ignition in "ACC" position. If not, check wiring.
- Connect negative lead of voltmeter to pin 15 and positive lead to pin 1. Rotate lever switch fully counterclockwise, with ignition switch at "ACC" position.
- Battery voltage should be present briefly every 3 seconds. If not, replace amplifier. If amplifier tests okay, problem is in wiper relay.