NX, Sentra, Pathfinder & Pickup

Disconnect speedometer cable from instrument cluster. Remove combination meter. Insert a small screwdriver into speedometer cable hole behind speedometer. Using an ohmmeter, check continuity between specified terminals while slowly rotating sensor with screwdriver. See SPEED SENSOR CONTINUITY CHECK  table for terminal specifications. See Fig 1-Fig 5 . While turning sensor, needle on ohmmeter should deflect twice per revolution.

Fig 1: Testing Vehicle Speed Sensor (Maxima, Stanza, 240SX & 300ZX)

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Rear View Of Combination Meter (240SX W/ Analog Speedo)

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 3: Rear View Of Combination Meter (240SX W/ Digital Speedo)

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 4: Rear View Of Combination Meter (300ZX W/ Options)

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 5: Rear View Of Combination Meter (300ZX W/O Options)

Courtesy of NISSAN MOTOR CO., U.S.A.