Engine Controls - System/Component Tests: Introduction

Before testing separate components or systems, perform procedures in BASIC TESTING article. Since many computer-controlled and monitored components set a trouble code if they malfunction, also perform procedures in TESTS W/CODES article.

NOTE: Testing individual components does not isolate shorts or opens. Perform all voltage tests with a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance, unless stated otherwise in test procedure. Use ohmmeter to isolate wiring harness shorts or opens.

NOTE: Become acquainted with the various symbols used in the diagnostic charts. See Figure .

NOTE: To identify ECU connector terminals, see PIN VOLTAGE CHART S article and WIRING DIAGRAMS article.