Removal & Installation
- Remove the drain plug. Drain transmission fluid. Remove the oil pan and gasket. Remove oil strainer. Remove control valve assembly by removing bolts and disconnecting the wiring harness connector. See the CONTROL VALVE ASSEMBLY BOLT IDENTIFICATION table. See Fig 1. Remove accumulators by applying compressed air (if necessary).
- To install control valve assembly, set manual valve in Neutral position and align with manual plate. Install control valve assembly and tighten bolts to 62-80 INCH lbs (7-9 N.m). To complete installation, reverse removal procedure. Fill transaxle to appropriate fluid level.
CONTROL VALVE ASSEMBLY BOLT IDENTIFICATION
| Identification |
In. (mm) |
| "A" |
1.713 (43.50) |
| "B" |
1.30 (33.00) |
| "C" |
1.57 (40.00) |
Courtesy of NISSAN MOTOR CO., U.S.A.