LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2002 >> Frontier Base, Automatic >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Controls - Self-Diagnostics >> Diagnostic Tests >> DTC P1148: Closed Loop Control - Bank 1 Or DTC P1168: Closed Loop Control - Bank 2 >> DTC Confirmation Test (Using Generic Scan Tool)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Confirmation Test (Using Generic Scan Tool)

NOTE: Use the following test to check overall function of closed loop fuel control. During this test, DTC may not be confirmed.
CAUTION: DO NOT use ECM ground terminals when measuring voltage.
  1. Start engine and warm to normal operating temperature. On 2.4L models, measure voltage between ground and ECM terminal No. 50 by backprobing. See Figure or Figure . See Figure . On 3.3L models, measure voltage between ground and ECM terminal No. 50 (bank 1) or No. 51 (bank 2) by backprobing.
  2. On all models, monitor voltmeter with engine at 2000 RPM. Voltage should be less than .21 volt at least once and more than .70 volt at least once. If voltage is not as specified, go to DIAGNOSTIC PROCEDURE  . If voltage is as specified, system is okay at this time.
scientia non olet · About LEMON Manuals