14. Check Ignition Coil Output Signal Circuit For Open And Short
WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect ECM harness connector.
- Check harness continuity between ECM terminals 60, 61, 62, 79, 80, 81 and ignition coil terminal 1.
Refer to Wiring Diagram.
- Continuity should exist.
- Also check harness for short to ground and short to power.
OK or NG
- OK : GO TO 16 .
- NG : GO TO 15.