CONSULT-II Function (BCM): Notes

WARNING: This page is about a different car, the 2005 Infiniti FX45 and 2005 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunction might be detected in self-diagnosis depending on control unit with carry out CAN communication.

CONSULT-II can display each diagnostic item using the diagnostic test modes shown.

Fig 1: BCM Diagnosis Test Item Content Chart

Courtesy of NISSAN MOTOR CO., U.S.A.

Turn ignition switch OFF.
Connect CONSULT-II and CONSULT-II CONVERTER to data link connector.

Fig 2: Identifying Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Turn ignition switch ON.
Touch "START (NISSAN BASED VHCL)".

Fig 3: Displaying "START (NISSAN BASED VHCL)" Mode
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "BCM".
If "BCM" is not indicated, go to "CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT ".

Fig 4: Displaying "BCM" Mode
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "THEFT ALM".

Fig 5: Displaying "THEFT ALM" Mode
Courtesy of NISSAN MOTOR CO., U.S.A.
Select diagnosis mode.
"DATA MONITOR", "ACTIVE TEST" AND "WORK SUPPORT"

Fig 6: Displaying "DATA MONITOR", "ACTIVE TEST" AND "WORK SUPPORT" Mode
Courtesy of NISSAN MOTOR CO., U.S.A.