Fail-Safe System Check

Turn ignition switch to ON position.
Turn CRUISE ON/OFF switch to ON and check if the "SET" indicator blinks.
If the indicator lamp blinks, check the following.
- ASCD steering switch. Refer to ASCD STEERING SWITCH
Drive the vehicle at more than 40 km/h (25 MPH) and push SET/COAST switch.
If the indicator lamp blinks, check the following.
- Vehicle speed sensor. Refer to VEHICLE SPEED SENSOR CHECK
- ASCD motor actuator circuit. Refer to ASCD MOTOR ACTUATOR CIRCUIT CHECK
- Replace control unit.
Drive the vehicle at more than 20 km/h (12 MPH).
If the indicator lamp blinks, replace the following.
- ASCD motor actuator.
Depress brake pedal slowly (brake pedal should be depressed more than 5 seconds).
If the indicator lamp blinks, check the following.
- ASCD brake/stop lamp switch. Refer to ASCD BRAKE/STOP LAMP SWITCH CHECK
END. (System is OK.)