Function and System Application
WARNING: This page is about a different car, the 2004 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
FUNCTION AND SYSTEM APPLICATION
| Diagnostic test mode | Function | ENGINE | A/T | ABS | AIR BAG | SMART ENTRANCE | NVIS (NATS)(1) | ||
|---|---|---|---|---|---|---|---|---|---|
| Work support | This mode enables a technician to adjust some devices faster and more accurate by following the indications on CONSULT-II. | x | x | - | - | - | - | ||
| Self-diagnostic results | Self-diagnostic results can be read and erased quickly. | x | x | x | x | - | x | ||
| Trouble diagnostic record | Current self-diagnostic results and all trouble diagnostic records previously stored can be read. | - | - | - | x | - | - | ||
| ECU discriminated No. | Classification number of a replacement ECU can be read to prevent an incorrect ECU from being installed. | - | - | - | x | - | - | ||
| Data monitor | Input/Output data in the ECU (ECM) can be read. | x | x | x | - | - | - | ||
| DTC work support | This mode enables a technician to set operating conditions to confirm self-diagnosis status/results. | - | x | - | - | - | - | ||
| Data monitor (Spec.) | The specified values will be displayed when an OK/NG judgement is difficult for the DATA MONITOR items by Bar Chart and Line Graph. | x | - | - | - | - | - | ||
| Active test | Diagnostic Test Mode in which CONSULT-II drives some actuators apart from the ECU (ECM) and also shifts some parameters in a specified range. | x | - | x | - | - | - | ||
| ECU (ECM) part number | ECU (ECM) part number can be read. | x | x | x | - | - | - | ||
| Control unit initialization | All registered ignition key IDs in NATS components can be initialized and new IDs can be registered. | - | - | - | - | - | x | ||
| Function test | Conducted by CONSULT-II instead of a technician to determine whether each system is "OK" or "NG". | x | - | - | x | - | - | ||
| SRT & DTC confirmation | The results of SRT (System Readiness Test) and the self-diagnosis status/results can be confirmed. | x | - | - | - | - | - | ||
| REMO CONT ID SET UP | A maximum of four IDs (identifications) can be registered in the memory using the remote controller. These IDs can also be confirmed and erased. | - | - | - | - | x | - | ||
| x: Applicable | |||||||||
|
|||||||||