Light Warning Chime

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2005 Infiniti FX45, 2005 Infiniti FX35, 2004 Infiniti FX45, 2004 Infiniti FX35, and 2003 Infiniti FX45. However, it is still accessible from the selected car via links, so may be relevant.

With the key removed from the ignition switch or when the ignition knob is in LOCK (push switch OFF) [with Intelligent Key], the driver's door is opened, and the lighting switch is in ON position, the warning chime will sound. [Except when headlamp battery saver control operates (for 5 minutes after ignition switch is turned to OFF or ACC position) and headlamps do not illuminate.]

Signal is supplied

From combination switch (lighting switch) terminals 1, 2, 3, 4, 5, 6, 7, 8, 9 and 10
To BCM terminals 2, 3, 4, 5, 6, 32, 33, 34, 35 and 36.
NOTE: BCM detected lighting switch in 1st or 2nd position, refer to "COMBINATION SWITCH READING FUNCTION ".

Ground is supplied

To BCM terminal 62
Through front door switch (driver side) terminal 1.

Front door switch (driver side) is case grounded.

BCM detects headlamps are illuminated, and sends light warning signal to unified meter and A/C amp. with CAN communication line. Unified meter and A/C amp. sends light warning signal to combination meter with communication line between unified meter and A/C amp. and combination meter.

When combination meter receives light warning signal, it sounds warning chime.