Control Device Removal and Installation: Removal

WARNING: This page is about a different car, the 2005 Nissan 350Z. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect lower lever of control device and control rod.
Remove knob cover below selector lever downward.
Pull lock pin out of selector lever knob.
Remove selector lever knob.
Remove console finisher (A/T ring) and console finisher.
- Refer to "COMPONENT PARTS DRAWING ".
Remove center console.
- Refer to "COMPONENT PARTS DRAWING ".
Remove key interlock cable from control device.
- Refer to "REMOVAL AND INSTALLATION ".
Fig 1: Removing Selector Lever Knob
Courtesy of NISSAN MOTOR CO., U.S.A.
Disconnect A/T device harness connector.
Remove control device assembly.
CAUTION: Do not impact, or damage propeller shaft tube.