Reclining Switch Inspection

With CONSULT-II 

With "RECLN SW-FR, RECLN SW-RR" on the DATA MONITOR, operate the reclining switch to check ON/OFF operation.

Fig 1: Identifying Display - Data Monitor

Courtesy of NISSAN MOTOR CO., U.S.A.

Without CONSULT-II 

1. Turn ignition switch OFF.
2. Check voltage between driver seat control unit connector and ground.
   Fig 2: Checking Voltage Between Driver Seat Control Unit Connector And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.
   VOLTAGE BETWEEN DRIVER SEAT CONTROL UNIT CONNECTOR AND GROUND REFERENCE
   
   

   Connector	Terminals (Wire color)		Condition	Voltage (V) (Approx.)
   	(+)	(-)
   P2	12 (O/B)	Ground	Reclining switch ON (BACKWARD operation)	0
   			Other than above	Battery voltage
   	27 (G/B)		Reclining switch ON (FORWARD operation)	0
   			Other than above	Battery voltage

OK or NG

• OK : Reclining switch circuit is OK.
• NG : GO TO 2.

1. Disconnect driver seat control unit and power seat switch LH.
2. Check continuity between driver seat control unit connector P2 terminals 12, 27 and power seat switch LH connector P8 terminals 9, 10.

   12 (O/B) - 9 (O/B) : Continuity should exist  .

   27 (G/B) - 10 (G/B) : Continuity should exist  .

3. Check continuity between driver seat control unit connector P2 terminals 12, 27 and ground.

   12 (O/B) - Ground : Continuity should not exist  .

   27 (G/B) - Ground : Continuity should not exist. LIIA1127E 

   Fig 3: Checking Continuity Between Driver Seat Control Unit Connector P2 Terminals 12, 97 And Power Seat Switch LH Connector P8 Terminals 9 And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

• OK : GO TO 3.
• NG : Repair or replace harness.

Check continuity between power seat switch LH as follows.

Fig 4: Checking Continuity Between Power Seat Switch LH

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

• OK : Check the condition of the harness and connector.
• NG : Replace power seat switch LH. Refer to "REMOVAL AND INSTALLATION ".