Sliding Door Remote Control Switch System Inspection

Check sliding door remote control switch operation.

OK or NG 

OK: Sliding door remote control switch is OK.

NG: GO TO 2.

1. Turn ignition switch OFF.
2. Close the sliding door.
3. While operating the sliding door remote control switch, check voltage between sliding door latch control unit connector D204 (LH) or D304 (RH) terminal 5 and ground.
   TERMINALS VOLTAGE CHART
   
   

   Terminal		Measuring condition	Voltage (V) (Approx.)
   ( + )	( - )
   5	Ground	Sliding door handle open direction operation	0
   		Other than above	5

   Fig 1: Checking Voltage Between Sliding Door Latch Control Unit Connector D204 Or D304 Terminal 5 And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: Sliding door remote control switch is OK.

NG: GO TO 3.

1. Disconnect sliding door remote control switch and sliding door latch control unit.
2. Check continuity between sliding door remote control switch connector D207 (LH) or D307 (RH) terminal 1 and sliding door latch control unit connector D204 (LH) or D304 (RH) terminal 5.

   1 - 5 : Continuity should exist. 

OK or NG 

OK: GO TO 4.

NG: Repair or replace harness.

Fig 2: Checking Continuity Between Sliding Door Remote Control Switch Terminal 1 And Sliding Door Latch Control Unit Terminal 5

Courtesy of NISSAN MOTOR CO., U.S.A.

1. Close the sliding door.
2. Check continuity between sliding door remote control switch connector D207 (LH) or D307 (RH) terminal 3 and ground.

   3 - Ground : Continuity should exist. 

OK or NG 

OK: Replace the sliding door remote control switch.

NG: Repair or replace harness.

Fig 3: Checking Continuity Between Sliding Door Remote Control Switch Connector D207 Or D307 Terminal 3 And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.