System Description: Inputs
WARNING: This page is about a different car, the 2004 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.
- Power is supplied at all times
- to BCM terminal 55
- through 50A fusible link (letter F , located in the fuse and fusible link box).
- to BCM terminal 42
- through 15A fuse [No. 22, located in the fuse and fusible link box).
- to remote keyless entry receiver terminal 4
- through BCM terminal 19.
- When the key switch is ON (key is inserted in ignition key cylinder), power is supplied
- to BCM terminal 37
- through key switch terminal 1 and 2
- through 15A fuse [No. 22, located in the fuse and fusible link box).
- When the ignition switch is ACC or ON, power is supplied
- to BCM terminal 11
- through 10A fuse [No. 6, located in the fuse block (J/B)].
- When the ignition switch is ON or START, power is supplied
- to BCM terminal 38
- through 10A fuse [No. 12, located in the fuse block (J/B)].
- Ground is supplied
- to remote keyless entry receiver terminal 1
- through BCM terminal 18.
- to BCM terminal 52
- through body grounds M30 and M66
- When the front door switch (driver side) is ON (door is OPEN), ground is supplied
- to BCM terminal 62
- through front door switch (driver side) terminal 1
- through front door switch (driver side) case ground.
- When the front door switch (passenger side) is ON (door is OPEN), ground is supplied
- to BCM terminal 12
- through front door switch (passenger side) terminal 1
- through front door switch (passenger side) case ground.
- When the rear door switch LH is ON (door is OPEN), ground is supplied
- to BCM terminal 63
- through rear door switch LH terminal 1
- through rear door switch LH case ground.
- When the rear door switch RH is ON (door is OPEN), ground is supplied
- to BCM meter terminal 13
- through rear door switch RH terminal 1
- through rear door switch RH case ground.
- Key fob signal is inputted to remote keyless entry receiver (the antenna of the system is built in remote keyless entry receiver).
Remote keyless entry receiver sends key fob signal
- to BCM terminal 20
- from remote keyless entry receiver terminal 2.
- The remote keyless entry system controls operation of the
- power door lock
- hazard and horn reminder
- auto door lock
- panic alarm
- keyless power window down (open)
- room lamp and key ring illumination