LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2002 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 682 (Remote Keyless Entry System - Coupe) >> Remote Keyless Entry System >> ID Code Entry Procedure >> Key FOB ID Setup With CONSULT-II
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Key FOB ID Setup With CONSULT-II

WARNING: This page is about a different car, the 2003 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • If a key fob is lost, the ID code of the lost key fob must be erased to prevent unauthorized use. When the ID code of a lost key fob is not known, all controller ID codes should be erased. After all ID codes are erased, the ID codes of all remaining and/or new key fobs must be re-registered.
  • When registering an additional key fob, the existing ID codes in memory may or may not be erased. If five ID codes are stored in memory, when an additional code is registered, only the oldest code is erased. If less than five ID codes are stored in memory, when an additional ID code is registered, the new ID code is added and no ID codes are erased.
  • Entry of maximum five ID codes is allowed. When more than five ID codes are entered, the oldest ID code will be erased.
  • Even if same ID code that is already in the memory is input, the same ID code can be entered. The code is counted as an additional code.
  1. Turn ignition switch "OFF".
  2. Connect "CONSULT-II" and "CONSULT-II CONVERTER" to the data link connector.
    Fig 1: Locating Data Link Connector
    G02057137Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Turn ignition switch ON.
  4. Touch "START (NISSAN BASED VHCL)".
    Fig 2: CONSULT-II Display Screen - Touch START (Nissan Based VHCL)
    G02057138Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Touch "BCM".

    If "BCM" is not indicated, go to , "CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT ".

    Fig 3: CONSULT-II Display Screen - Touch BCM
    G02057139Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Touch "MULTI REMOTE ENT".
    Fig 4: CONSULT-II Display Screen - Touch MULTI REMOTE ENT
    G02057140Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Touch "WORK SUPPORT".
    Fig 5: CONSULT-II Display Screen - Touch Work Support
    G02057141Courtesy of NISSAN MOTOR CO., U.S.A.
    8. NOTE: Register the ID code when key fob or BCM is replaced, or when additional key fob is required.
  8. The items shown on the figure can be set up.
    • "REMO CONT ID CONFIR" Use this mode to confirm if a key fob ID code is registered or not.
    • "REMO CONT ID REGIST" Use this mode to register a key fob ID code.
    • "REMO CONT ID ERASER" Use this mode to erase a key fob ID code.
      Fig 6: CONSULT-II Display Screen - Select Work Item
      G02057142Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals