Pattern B

WARNING: This page is about a different car, the 2003 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

With any door (including hood and glass hatch) open, if lock/unlock switch is used to lock doors, smart entrance control unit terminal 33 receives a LOCK signal

from terminal 14 of lock/unlock switch LH or
from terminal 16 of lock/unlock switch RH, or

With any door (including hood and glass hatch) open if the key is used to lock doors, smart entrance control unit terminal 33 receives a LOCK signal from power window main front switch terminal 14. Refer to POWER WINDOW SERIAL LINK .

When key cylinder switch LOCK signal ground is supplied

to power window main switch terminal 4
from terminal 3 of the front door key cylinder switch LH
through terminal 2 of front door key cylinder switch LH
through body grounds M4, M66, M111, M147 and M157, or smart entrance control unit terminal 11 receives a ground signal
from terminal 1 of the back door key cylinder switch
through body grounds B11, B22 and D210.

If these signals and lock signal from keyfob are received by the smart entrance control unit, ground signals of terminals 1, 2 and 3 are interrupted and all doors are closed, the vehicle security system will activate automatically.

NOTE: Vehicle security system can be set even though the rear door is not locked.

Once the vehicle security system has been activated, smart entrance control unit terminal 38 supplies ground to terminal 2 of the security indicator lamp.

The security lamp will illuminate for approximately 30 seconds and then blinks every 2.6 seconds.

Now the vehicle security system is in armed phase.