Input Signal Check Mode
WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
Input signal check mode allows testing of switch input signal to the sliding door control unit.
To activate input signal check mode on the automatic sliding door, perform the following steps:
- Turn ignition switch OFF.
- Turn automatic door main switch OFF (system cancelled).
- Place A/T selector lever in P position.
- Confirm fuel door closed (with LH sliding door).
- Open sliding door RH or LH manually.
- Have an assistant press and hold the sliding door open/close switch RH or LH.
- While the assistant continues to hold the sliding door open/close switch RH or LH, turn ignition switch ON (DO NOT start engine).
- After approximately 5 seconds, the back door warning chime will sound for 0.5 seconds.
- Release the sliding door open/close switch RH or LH.
- Within 8 seconds of the back door warning chime sounding, press and hold the automatic door main sliding door open/close switch RH or LH.
- After approximately 5 seconds, the back door warning chime will sound for 1 second.
- Release the automatic door main sliding door open/close switch RH or LH.
- The input signal check mode is now initialized.
The input signal check mode can test the following inputs. The back door warning chime will sound for approximately 0.5 seconds each time a switch signal input occurs. Use this test when one of these inputs is not responding during normal automatic sliding door operation.
TERMINALS SIGNAL CHART
| Switch signal | Operation | ||
|---|---|---|---|
| automatic Door Main Switch. Refer to AUTOMATIC DOOR MAIN SWITCH SYSTEM INSPECTION . | OFF → ON | ||
| Automatic Door Main Sliding Door Open/Close Switch RH Or LH. Refer to AUTOMATIC DOOR MAIN SWITCH SYSTEM INSPECTION . | OFF → ON | ||
| SLIDING DOOR OPEN/CLOSE SWITCH RH OR LH | OFF → ON | ||
| SLIDING DOOR SWITCH RH OR LH | OFF (door closed) → ON (door open) | ||
| A/T device (park position switch) | P position → other than P position. Refer to A/T DEVICE (PARK POSITION SWITCH) CIRCUIT INSPECTION . | ||
| FUEL DOOR INTERLOCK SWITCH | OFF (fuel door closed) → ON (fuel door open) | ||
| SLIDING DOOR LOCK/UNLOCK SIGNAL | LOCK → UNLOCK | ||
| VEHICLE SPEED (1) | Vehicle speed | ||
| REMOTE KEYLESS ENTRY SIGNAL KEYFOB SWITCH | OFF → ON | ||
| DOOR SWITCH CHECK (WITH AUTOMATIC BACK DOOR SYSTEM) | LOCK → UNLOCK | ||
|
|||
Turn ignition switch OFF to end input signal check mode.