Color of RGB Image is Not Proper (Except NAVI Screen looks reddish)

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK RGB HARNESS

Turn ignition switch OFF.
Disconnect display control unit connector M95 and display unit connector M93.
Check continuity between display control unit and display unit.
Check continuity between display control unit and ground.

When the screen looks reddish.

RGB HARNESS - SCREEN LOOKS REDDISH (1 OF 2)

Terminals				Continuity
Display control unit (+)		Display unit (-)
Connector	Terminal	Connector	Terminal
M95	52	M93	6	Yes
M95	47	M93	7	Yes

RGB HARNESS - SCREEN LOOKS REDDISH (2 OF 2)

Terminals			Continuity
Display control unit (+)		(-)
Connector	Terminal	(-)
M95	52	Ground	No
M95	47	Ground	No

Fig 1: Checking Continuity Between Display Control Unit And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: GO TO 2.

NG: Repair harness or connector.

CHECK RGB SIGNAL
1. Connect display control unit connector and display unit connector.
2. Turn ignition switch ON.
3. Display "Color bar" by "CONFIRMATION/ADJUSTMENT" mode.
4. Check the following with CONSULT-III or oscilloscope.
- When the screen looks reddish.
  Voltage signal between display control unit connector M95 terminal 52 and 47.
  
  52 - 47: Refer to "TERMINALS AND REFERENCE VALUE FOR DISPLAY CONTROL UNIT ".
Fig 2: Checking Voltage Signal Between Display Control Unit Connector M95 Terminal 52 And 47
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Replace display unit. Refer to "DISPLAY UNIT ".

NG: Replace display control unit. Refer to "DISPLAY CONTROL UNIT ".