Daytime Light Control Unit Inspection Table

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

DAYTIME LIGHT CONNECTOR TERMINAL INSPECTION CHART

Terminal No.	Wire color	Item	Condition	Voltage (Approx.)
1	BR/W	Ignition switch start signal	Ignition switch in START position	Battery voltage
1	BR/W	Ignition switch start signal	All other conditions	0V
2	SB	Battery	Ignition switch in all positions	Battery voltage
3	SB	Battery	Ignition switch in all positions	Battery voltage
4	L	Lighting switch headlamp LH low beam output	Lighting switch in the headlamp ON (2ND) position and low beam (B) position	Battery voltage
4	L	Lighting switch headlamp LH low beam output	All other conditions	0V
5	G	Lighting switch headlamp LH high beam output	Lighting switch in the flash-to-pass (C) position or headlamp ON (2ND) position and high beam (A) position	Battery voltage
5	G	Lighting switch headlamp LH high beam output	All other conditions	0V
6	L/W	Headlamp LH high beam	Lighting switch in the flash-to-pass (C) position or headlamp ON (2ND) position and high beam (A) position	Battery voltage
			With parking brake released, engine running and lighting switch in OFF or parking and tail lamp ON (1ST) positions CAUTION: Block wheels and ensure selector lever is in P or N position.	Battery voltage
			All other conditions	0V
7	Y/G	Headlamp LH (high) control	Lighting switch in the flash-to-pass (C) position or headlamp ON (2ND) position and high beam (A) position and high beam position	0V
			With parking brake released, engine running and lighting switch in OFF or parking and tail lamp ON (1ST) positions CAUTION: Block wheels and ensure selector lever is in P or N position.	Battery voltage
			All other conditions	0V
8	Y	Lighting switch headlamp RH high beam output	Lighting switch in the flash-to-pass (C) position or headlamp ON (2ND) position and high beam (A) position	Battery voltage
			With parking brake released, engine running and lighting switch in OFF or parking and tail lamp ON (1ST) positions CAUTION: Block wheels and ensure selector lever is in P or N position.	6V
			All other conditions	0V
9	B	Ground	-	-
10	Y/G	Parking brake switch	Parking brake released	Battery voltage
10	Y/G	Parking brake switch	Parking brake set	0V
11	BR/Y	Generator (L terminal)	When engine is running	Battery voltage
11	BR/Y	Generator (L terminal)	All other conditions	0V
12	G	Ignition switch on signal	Ignition switch OFF, ACC positions	0V
12	G	Ignition switch on signal	Ignition switch ON, START positions	Battery voltage