Function and System Application
WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
FUNCTION AND SYSTEM APPLICATION CHART
| Diagnostic test mode | Function | ENGINE | A/T | AIR BAG | ABS/ TCS | BCM | ||
| Work support | This mode enables a technician to adjust some devices faster and more accurately by following the indications on CONSULT-II. | (1) | - | - | (1) | (1) | ||
| DTC work support | Select the operating condition to confirm Diagnosis Trouble Codes. | (1) | (1) | - | - | - | ||
| Self-diagnostic results | Self-diagnostic results can be read and erased quickly. | (1) | (1) | (1) | (1) | (1) | ||
| Trouble diagnostic record | Current self-diagnostic results and all trouble diagnostic records previously stored can be read. | - | - | (1) | - | - | ||
| ECU discriminated No. | Classification number of a replacement ECU can be read to prevent an incorrect ECU from being installed. | - | - | (1) | - | - | ||
| Data monitor | Input/Output data in the ECM can be read. | (1) | (1) | - | (1) | (1) | ||
| Active test | Diagnostic Test Mode in which CONSULT-II drives some actuators apart from the ECMs and also shifts some parameters in a specified range. | (1) | - | - | (1) | (1) | ||
| DTC confirmation | The results of SRT (System Readiness Test) and the self-diagnosis status/result can be confirmed. | (1) | - | - | - | - | ||
| ECM part number | ECM part number can be read. | (1) | (1) | - | (1) | - | ||
| Function test | Conducted by CONSULT-II instead of a technician to determine whether each system is "OK" or "NG". | (1) | - | - | - | - | ||
| Control unit initialization | All registered ignition key IDs in NATS components can be initialized and new IDs can be registered. | - | - | - | - | - | ||
| Self-function check | ECM checks its own NATS communication interface. | - | - | - | - | - | ||
|
||||||||