Check Outside Key Antenna

Push each door request switch, and use an oscilloscope to check voltage waveform of harness between Intelligent Key unit connector M34 terminals 17 (back door), 19 (driver and rear LH door), and 37 (passenger and rear RH door) and ground.

Fig 1: Connector Terminal Reference Chart

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Checking Outside Key Antenna Power Supply

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

1. OK : GO TO 2.
2. NG : GO TO  3.

1. Disconnect each outside key antenna connector.
2. Check the following.

• Check continuity between door mirror (outside key antenna) connector D2 (driver side), D32 (passenger side) terminals 6 and 7
• Check continuity between outside key antenna D62 (rear door LH), D82 (rear door RH), D116 (back door) terminals 1 and 2
  1. Driver side, Passenger side 
  2. 6 - 7 : Continuity should exist. 
  3. Back door, Rear door 
  4. 1 - 2 : Continuity should exist. 

OK or NG 

1. OK : GO TO 3.
2. NG : Replace outside key antenna.

Fig 3: Checking Outside Key Antenna Operation

Courtesy of NISSAN MOTOR CO., U.S.A.

1. Disconnect Intelligent Key unit connector.
2. Check continuity between each outside key antenna connector D2 (driver side), D32 (passenger side), D62 (rear door LH), D82 (rear door RH), D116 (back door) terminals 1, 2, 6, 7 and Intelligent Key unit connector M34 terminals 17, 18, 19, 20, 37, and 38.
   Fig 4: Connector Terminal Reference Chart

   Courtesy of NISSAN MOTOR CO., U.S.A.
3. Check continuity between each out side key antenna connector terminals 1, 2, 6, 7 and ground.
   Fig 5: Connector Terminal Reference Chart

   Courtesy of NISSAN MOTOR CO., U.S.A.
   Fig 6: Checking Outside Key Antenna Circuit

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

1. OK : Replace Intelligent Key unit.
2. NG : Replace harness between outside key antenna and Intelligent Key unit.