Seat Position Sensor: Installation

WARNING: This page is about a different car, the 2006 Scion tC. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see PRECAUTION )).

INSTALL SEAT POSITION AIR BAG SENSOR
1. Using a feeler gauge 1 mm (0.039 in.), install the seat position sensor.
  NOTE:
  - If the seat position sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position sensor with a new one.
  - When installing the seat position sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
  HINT:
  
  Be sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm (0.023 in.) to 1.4 mm (0.055 in.).
2. Using a "torx" socket (T30), tighten the "torx" screw to install the seat position sensor.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
3. Make sure that a clearance between the seat position sensor and the seat rail is within 0.6 mm (0.023 in.) to 1.4 mm (0.055 in.).
4. Connect the connector.
5. Install the seat slide position sensor protector to the seat position sensor.
INSTALL FRONT SEAT ASSEMBLY
1. Install the front seat (see INSTALLATION ).
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
CHECK SRS WARNING LIGHT
1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).