Testing Condition:

WARNING: This page is about a different car, the 2006 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Perform "DTC WORK SUPPORT" when the fuel level is between 1/4 and 3/4 full, and vehicle is placed on flat level surface.
Always perform test at a temperature of 0 to 30°C (32 to 86°F).

Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.

Fig 1: CONSULT-II Display - Data Monitor
Courtesy of NISSAN MOTOR CO., U.S.A.
Make sure that the following conditions are met.
COOLAN TEMP/S: 0 - 70°C (32 - 158°F)

INT/A TEMP SE: 0 - 30°C (32 - 86°F)
Select "EVP SML LEAK P0442/P1442" of "EVAPORATIVE SYSTEM" in "DTC WORK SUPPORT" mode with CONSULT-II.
Follow the instruction displayed.

Fig 2: Consult-II EVAP SMALL LEAK Display Screen
Courtesy of NISSAN MOTOR CO., U.S.A.

NOTE: If the engine speed cannot be maintained within the range displayed on the CONSULT-II screen, go to "BASIC INSPECTION ".
Make sure that "OK" is displayed.

If "NG" is displayed, refer to "DIAGNOSTIC PROCEDURE "

NOTE: Make sure that EVAP hoses are connected to EVAP canister purge volume control solenoid valve properly.

Fig 3: CONSULT II Display - EVAP SML LEAK

Courtesy of NISSAN MOTOR CO., U.S.A.