Consult-II Basic Operation Procedure

WARNING: This page is about a different car, the 2004 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.

With ignition switch OFF, connect "CONSULT-II" and "CONSULT-II CONVERTER" to data link connector, then turn ignition switch ON.

Fig 1: Identifying Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "START (NISSAN BASED VHCL)".

Fig 2: Consult II Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "IVMS" on "SELECT SYSTEM" screen. If "IVMS" is not indicated, refer to "CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT ".

Fig 3: Select System Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Check the model specification, touch either "WITH SUNROOF" or "WITHOUT SUNROOF".

Fig 4: Checking Model Specification
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "OK". If the selection is wrong, touch "CANCEL".
Select the desired part to be diagnosed on "SELECT TEST ITEM" screen.