Section 1263 (Front Axle): Precautions: Precautions

WARNING: This page is about a different car, the 2004 Nissan Altima, 2003 Nissan Altima, and 2002 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.

When installing rubber parts, final tightening must be carried out under unladen condition* with tires on ground. *: Fuel, radiator coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions.
After installing removed suspension parts, check wheel alignment and adjust if necessary.
Use flare nut wrench when removing or installing brake tubes.
Always torque brake lines when installing.

Fig 1: Identifying Commercial Service Tool
Courtesy of NISSAN MOTOR CO., U.S.A.