Setting Change Function

WARNING: This page is about a different car, the 2005 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

The settings of the automatic driving positioner system can be changed, using CONSULT-II and the display in the center of the instrument panel.

SETTING CHANGE FUNCTION (1 OF 2)

Setting item

Content

CONSULT-II (WORK SUPPORT)

Display unit

Default setting

Factory setting

SEAT SLIDE VOLUME SET

The distance at exiting operation can be selected from the following 3 modes.

40mm

⁽²⁾

⁽¹⁾

80mm

⁽²⁾

150mm

⁽²⁾

Sliding Front Seat When Entry/ Exiting Vehicle

The seat sliding turnout and return at entry/exit can be selected: ON (operated)-OFF (not operated)

ON: Indicator lamp ON

⁽²⁾

⁽¹⁾

OFF

OFF: Indicator lamp OFF

⁽¹⁾

⁽²⁾

Reset custom settings⁽³⁾

All settings to default.

⁽²⁾

Default: Setting button ON

⁽²⁾

⁽¹⁾	Applicable

⁽²⁾	Not applicable

⁽³⁾	Setting of sliding front seat for entry/exit of vehicle is ON at factory-shipment. But if custom settings are reset, setting turns OFF.

It is possible to set sliding front seat for entry/exit of vehicle by pressing set switch.

SETTING CHANGE FUNCTION (2 OF 2)

Content	Setting change operation	Indicator LEDs
The seat sliding turnout and return at entry/exit can be operated.	Press the set switch for more than 10 seconds	Blinking twice
The seat sliding turnout and return at entry/exit can not be operated.	Press the set switch for more than 10 seconds	Blinking once

NOTE: After the setting is registered, the new setting is effective, even if the battery is disconnected.