System Description: Inputs

Power is supplied at all times

• to BCM (body control module) terminal 70
• through 50A fusible link (letter g  , located in the fuse and fusible link box).
• to BCM terminal 57
• through 10A fuse [No. 18, located in the fuse block (J/B)].

When the key is inserted in the ignition cylinder (key switch), power is supplied

• to BCM terminal 37
• through key switch terminals 1 and 2
• through 10A fuse (No. 25, located in the fuse and fusible link box).

When the ignition switch is ACC or ON, power is supplied

• to BCM terminal 11
• through 10A fuse [No. 4, located in the fuse block (J/B)].

When the ignition switch is ON or START, power is supplied

• to BCM terminal 38
• through 10A fuse [No. 1, located in the fuse block (J/B)].

When the front door switch LH is ON (door is OPEN), ground is supplied

• to BCM terminal 47
• through front door switch LH terminal 2
• through front door switch LH case ground.

When the front door switch RH is ON (door is OPEN), ground is supplied

• to BCM terminal 12
• through front door switch RH terminal 2
• through front door switch RH case ground.

When the rear door switch LH is ON (door is OPEN), ground is supplied

• to BCM terminal 48
• through rear door switch LH terminal 2
• through rear door switch LH case ground.

When the rear door switch RH is ON (door is OPEN), ground is supplied

• to BCM terminal 13
• through rear door switch RH terminal 2
• through rear door switch RH case ground.

When the back door switch is ON (door is OPEN), ground is supplied

• to BCM terminal 43
• through back door switch terminal 3,
• through back door switch terminal 1,
• through body grounds D406 and D504.

Keyfob signal is inputted to BCM from the remote keyless entry receiver.

The remote keyless entry system controls operation of the

• power door lock
• interior lamp and ignition keyhole illumination
• panic alarm
• hazard and horn reminder
• auto door lock operation