Checking Equipment

WARNING: This page is about a different car, the 2006 Nissan Xterra. However, it is still accessible from the selected car via links, so may be relevant.

When ordering the below equipment, contact your NISSAN distributor .

TOOL NAME DESCRIPTION

Tool name	Description
NISSAN CONSULT-II (J-44200) CONSULT-II unit (Tester internal soft: Resident version 3.4.0) and accessories. Program cards UED05B-1 and AEN04A-1 (For NATS) or later. To confirm the best combination of these software, refer to . CONSULT-II CONVERTER. "CONSULT-II Pigtail" cable.

CAUTION:

Previous CONSULT-II "I" and "Y" DLC-I and DLC-II cables should NOT be used anymore because their DDL connector pins can be damaged during cable swapping.
If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self- diagnosis depending on control unit which carries out CAN communication.
If CONSULT-II CONVERTER is not connected with CONSULT-II, the vehicle enters "FAIL SAFE MODE" which will "LIGHT UP the HEAD LIGHT" and /or "COOLING FAN ROTATING" when CONSULT-II is started.

The CONSULT-II must be used in conjunction with a program card. CONSULT-II does not require loading (Initialization) procedure.
Be sure the CONSULT-II is turned OFF before installing or removing a program card.