LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2012 (Automatic Air Conditioner) >> Intake Sensor >> Removal and Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front kick plate. Refer to "KICK PLATES ".
  2. Remove the lower dash side finisher. Refer to "LOWER DASH SIDE FINISHER ".
  3. Remove the front pillar lower finisher. Refer to "FRONT PILLAR LOWER FINISHER ".
  4. Remove the assist grip handle.
  5. Remove the front pillar upper finisher. Refer to "FRONT PILLAR UPPER FINISHER ".
  6. Remove the lower glove box. Refer to "LOWER INSTRUMENT PANEL RH AND LOWER GLOVE BOX ".
  7. Remove the upper glove box (cluster lid E). Refer to "INSTRUMENT PANEL ".
  8. Disconnect the intake sensor electrical connector.
    NOTE: The intake sensor is located on the top of the front heater and cooling unit assembly next to the A/C evaporator cover.
  9. Twist the intake sensor to remove the intake sensor from the front heater and cooling unit assembly.
    Fig 1: Identifying Intake Sensor And Front Heater And Cooling Unit Assembly
    G04903481
scientia non olet · About LEMON Manuals