System Description: Notes

WARNING: This page is about a different car, the 2008 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Refer to Owner's Manual for Automatic Drive Positioner system operating instructions.
The settings (ON/OFF) of the automatic sliding seat (entry/exiting operation) at entry/exit can be changed as desired, using the display unit in the center of the instrument panel. The set content is transmitted by CAN communication, from display control unit to driver seat control unit.
Using CONSULT-III, the seat slide amount at entry/exit setting can be changed.

CONSULT-III FUNCTION CHART

Function		Description
Memory operation		The front seat LH, pedal (accelerator, brake) and door mirrors move to the stored driving position by pushing seat memory switch (1 or 2).
Entry/exiting function	Exiting operation	At exit, the front seat LH moves backward. (exiting position)
Entry/exiting function	Entry operation	At entry, the front seat LH returns from exiting position to the previous driving position before the exiting operation.
Keyfob interlock operation		Perform a linked memory operation by pressing keyfob unlock button.

NOTE:

Disconnecting the battery erases the stored memory.
After connecting the battery, insert the key into the ignition cylinder, turn ignition switch ON-->OFF and then operate the front door switch LH ON (open)-->OFF (close)-->ON (open)-->OFF (close), the entry/exiting function becomes possible.
After exiting operation is carried out, return operation can be operated.

AUTO OPERATION TEMPORARY STOP CONDITIONS CHART

Auto operation temporary stop conditions.

When ignition switch is turned to START during seat memory switch operation and return operation, seat memory switch operation and return operation is stopped.

Auto operation stop conditions.

When the vehicle speed becomes 7 km/h (4 MPH) or higher (memory switch operation and entry operation).
When the setting switch, seat memory switch 1 or 2 are pressed.
When A/T selector lever is in any position other than P.
When the door mirror switch is operated (when ignition switch turned to ON).
When power seat switch LH turned ON.
When pedal adjusting switch turned ON.
When front seat sliding entry/exiting setting is OFF (entry/exiting operation).

NOTE: During automatic operation, if the ignition switch is turned ON-->START, the automatic operation is suspended. When the ignition switch returns to ON, it resumes.