LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2320 (Engine Control System - Component Testing (Coupe)) >> ASCD Brake Switch >> Component Inspection >> Stop Lamp Switch
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Stop Lamp Switch

WARNING: This page is about a different car, the 2006 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch OFF.
  2. Disconnect stop lamp switch harness connector.
  3. Check continuity between stop lamp switch terminals 3 and 4 under the following conditions.
    TERMINAL CONTINUITY CHART

    Condition Continuity
    Brake pedal: Fully released Should not exist
    Brake pedal: Slightly depressed Should exist

    If NG, adjust stop lamp switch installation, refer to "BRAKE PEDAL ", and perform step 3 again.

    Fig 1: Checking Continuity Between Stop Lamp Switch Terminals 3 And 4
    G04180225Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals