Journal Assembly

WARNING: This page is about a different car, the 2004 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

Assemble the journal bearings. Apply multipurpose grease on the bearing inner surface.
NOTE: During assembly, use caution so that the needle bearings do not fall out.

Fig 1: Assembling The Journal Bearings
Courtesy of NISSAN MOTOR CO., U.S.A.
Select snap rings that will provide the specified play in an axial direction of the journal, and install them. Refer to SNAP RING .
NOTE: Select snap rings with a difference in thickness at both sides within 0.02 mm (0.0008 in).

Fig 2: Snap Ring
Courtesy of NISSAN MOTOR CO., U.S.A.
Adjust the thrust clearance between the bearing and snap ring to zero by tapping the yoke.

Fig 3: Adjusting The Thrust Clearance
Courtesy of NISSAN MOTOR CO., U.S.A.
Make sure that the journal moves smoothly and is below the propeller shaft joint flex effort specification.

Propeller shaft joint flex effort : 1.96 N.m (0.20 kg-m, 17 in-lb) or less

Fig 4: Ensuring Journal Moves Smoothly

Courtesy of NISSAN MOTOR CO., U.S.A.